TP-LINK TL-WA500G Access Point Drivers Windows XP


Download Now
TP-LINK TL-WA500G Access Point Driver

: TP-Link TL-WAG 54Mbps eXtended Range Wireless Access Point: Electronics. TP-LINK TL-WAG Access Point Firmware V1_ free download. Get the latest version now. 54Mbps eXtended Range Wireless Access. The example device is TP-Link TL-WAG N It operates in b/g standard, in one of the modes: Access Point, Access Point Client, Repeater, Bridge.


TP-LINK TL-WA500G Access Point Driver for Windows

Type: Driver
Rating:
4.76
358 (4.76)
Downloads: 663
File Size: 9.92Mb
Supported systems: Windows 7/8/10, Windows XP 64-bit, Mac OS X 10.X
Price: Free* [*Free Registration Required]

Download Now
TP-LINK TL-WA500G Access Point Driver

Use a paper clip or something sharp While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds While still holding the reset button down, turn on the TP-LINK TL-WA500G Access Point to the unit again and hold for another 30 seconds. This process usually works for resetting any router to it's factory setting.

Hence to access the configuration setup of this device, it needs to be connected directly to a computer. To ensure that the computer can communicate with the TL-WAG properly, its IP address and subnet mask of the must be manually set to a static address in the same subnet — say TP-LINK TL-WA500G Access Point setting up the computer, follow the steps below to access and set the parameters for the access point and the wireless network.

Power up the access point and connect it to the computer using the Ethernet cable provided On the computer browser type in the following link: From this screen, one can navigate to any other menu item to configure various parameters of the access point. The default TP-LINK TL-WA500G Access Point address of this access point is set to Hence to access the configuration setup of this device, it needs to be connected directly to a computer.

To ensure that the computer can communicate with the TL-WAG properly, its IP address and subnet mask of the must be manually set to a static address in the TP-LINK TL-WA500G Access Point subnet — say After setting up the computer, follow the steps below to access and set the parameters for the access point and the wireless network. Power up the access point and connect it to the computer using the Ethernet cable provided On the computer browser type in the following link: And please note that the IP addresses of the two access points cannot be the same in your network.

Press Survey or Search button on the bottom, then an AP list TP-LINK TL-WA500G Access Point be displayed.

TP-LINK TL-WA500G Access Point Driver for Windows 7

Click on Save button to save the settings. Go to System Tools-Reboot to reboot the device.

TP-LINK TL-WA500G Access Point Drivers PC

Related Posts